Retaining wall drainage

Water is the main reason block walls bulge or fail. Wet soil is heavier and pushes harder, and in cold climates it freezes and heaves. A drained wall has clean stone behind the blocks for their full height, a perforated drain pipe along the back of the base that exits to daylight or a drain, and often filter fabric between the stone and the soil so fines do not clog it. RetainingWallCalc gives the stone and pipe quantities for your wall.

Feet and inches
Base and drainage settings
Prices (optional)

      Saved you some time? Leave a tip, entirely optional.

      Slope the ground above the wall away from it, and never point gutters or downspouts at the top of a retaining wall.

      How the retaining wall calculator works

      RetainingWallCalc divides the wall length (in inches) by the block face length and rounds up to get the blocks per course. It divides the exposed height by the block height for the courses above ground, then adds enough buried courses to reach the bury depth: 1 inch per 8 inches of exposed height, at least 6 inches. Blocks = blocks per course × courses, plus your waste allowance. Caps = wall length ÷ cap length, plus the same allowance.

      The base trench is the block depth plus the extra width you set (12 inches gives 6 inches in front and behind), at the base depth, plus a compaction allowance. Drainage stone fills a zone behind the blocks for their full height. Cubic yards are converted to tons with the density you enter.

      Typical block sizes

      Block (face × height × depth)Blocks per sq ft of faceTypical use
      Small garden wall block 12 × 4 × 7 in3Garden edging, raised beds, walls to about 2 ft
      Medium retaining block 16 × 6 × 10 in1.5Landscape walls to about 3 ft
      Large retaining block 18 × 8 × 12 in1Retaining walls to about 4 ft without geogrid (check the maker)

      Bury depth by wall height

      Exposed heightMinimum buried block
      2 ft (24″)6″
      3 ft (36″)6″
      4 ft (48″)6″
      5 ft (60″)7.5″
      6 ft (72″)9″

      Bury depth, 6-inch base and 12-inch drainage zone are common manufacturer guidance for segmental block walls; your block system's installation guide wins. Walls retaining more than 48 inches of soil need an engineered design under the IRC (R404.4), as do walls with slopes, driveways or buildings above them. Results are estimates: confirm quantities with your supplier and call 811 (US) before you dig.

      Frequently asked questions

      Does a short retaining wall need a drain pipe?

      Many block makers recommend one for walls over about 2 feet or wherever water collects. It is cheap insurance compared with rebuilding a wall.

      Where does the drain pipe go?

      At the back of the base behind the bottom course, sloped to drain to daylight at the ends of the wall or to a storm drain.

      Do I need landscape fabric?

      Filter fabric between the drainage stone and the retained soil helps keep the stone clean; check your block system's guide.

      Is RetainingWallCalc free?

      Yes, with no sign-up or ads.

      Are my measurements saved?

      Yes, in this browser only.

      More tools